Configuration Guide User guide

BigIron RX Series Configuration Guide 1451
53-1002484-04
Rate limiting
E
Rate limiting
qos scheduler destination-weighted <queue0-weight>
<queue1-weight> <queue2-weight> <queue3-weight>
“Configuring WFQ destination-based traffic
scheduling” on page 502
qos scheduler enhanced-strict
<queue0-rate>
<queue1-rate> <queue2-rate> <queue3-rate>
“Configuring enhanced strict priority-based traffic
scheduling” on page 502
qos scheduler max-rate
<queue0-rate> <queue1-rate>
<queue2-rate> <queue3-rate>
“Configuring maximum rate-based traffic scheduling”
on page 503
qos scheduler min-rate
<queue0-rate> <queue1-rate>
<queue2-rate> <queue3-rate>
“Configuring minimum rate-based traffic scheduling”
on page 504
qos scheduler source-weighted
<queue0-weight>
<queue1-weight> <queue2-weight> <queue3-weight>
“Configuring WFQ source-based traffic scheduling”
on page 503
qos scheduler strict “Configuring strict priority-based traffic scheduling”
on page 501
qos-tos map cos-dscp
<dscp0> <dscp1> <dscp2>
<dscp3> <dscp4> <dscp5> <dscp6> <dscp7>
“Changing the CoS –> DSCP mappings” on page 487
qos-tos map cos-priority
<prio0>
<prio1><prio2><prio3><prio4><prio5><prio6>
<prio7>
“Changing the DSCP –> internal forwarding priority
mappings” on page 488
qos-tos map dscp-dscp
<old-dscp-value>
[
<old-dscp-value>...]
to
<new-dscp-value>
“Changing the DSCP –> DSCP mappings” on
page 488
qos-tos map dscp-priority
<dscp-value> [<dscp-value> ...]
to
<priority>
“Changing the DSCP –> internal forwarding priority
mappings” on page 488
qos-tos mark cos | dscp “Enabling marking” on page 487
qos-tos trust cos | dscp “Specifying trust level” on page 486
qos-tos “Enabling ToS-based QoS” on page 486
show qos multicast [port-no] “Displaying the multicast traffic engineering
configuration” on page 506
show qos scheduler “Displaying the scheduler configuration” on
page 504
show qos wred “Displaying the WRED configuration” on page 500
show qos-tos “Displaying QoS configuration information” on
page 490
static-mac-address
<mac-addr> ethernet <portnum>
[priority
<num>]
“Assigning static MAC address entries to priority
queues” on page 485
Commands See ...
Commands See ...
rate-limit in access-group <number> |
named-access-group
<acl-name> <average-rate>
<maximum-burst>
“Configuring a port-and-ACL-based traffic policing
policy” on page 517
rate-limit in ipv6-named-access-group
<name>
<average-rate> <maximum-burst>
“Configuring a port-and-priority-based rate limiting
policy” on page 515