Configuration Guide User guide

1454 BigIron RX Series Configuration Guide
53-1002484-04
RSTP
E
RSTP
Security/Management
802.1x Port Security
Commands See ...
rstp [admin-edge-port] | [admin-pt2pt-mac] “Changing port parameters” on page 389
rstp ethernet
<portnum> path-cost <value> | priority
<value> | [admin-edge-port] | [admin-pt2pt-mac] |
[force-migration-check]
“Changing port parameters” on page 389
rstp single “Enabling or disabling RSTP on a single spanning
tree” on page 388
rstp “Enabling or disabling RSTP in a port-based VLAN” on
page 387
show rstp [vlan
<vlan-id>] “Displaying RSTP information” on page 394
show rstp detail [vlan
<vlan-id>] “Displaying RSTP information” on page 394
show xstp ethernet
<slot/port> “Displaying RSTP information for the specified
Ethernet interface” on page 399
spanning-tree 802-1w [forward-delay
<value>] |
[hello-time
<value>] | [max-age <time>] | [force-version
<value>] | [priority <value>]
“Changing RSTP bridge parameters” on page 388
spanning-tree “Disabling or enabling RSTP on a port” on page 388
Commands See ...
aaa authentication dot1x default <method-list> “Configuring an authentication method list for
802.1x” on page 1053
auth-fail-action restricted-vlan “Specifying the authentication-failure action” on
page 1063
auth-fail-max-attempts
<attempts> “Specifying the number of authentication attempts
the device makes before dropping packets” on
page 1063
auth-fail-vlanid
<vlan-id> “Specifying the authentication-failure action” on
page 1063
clear dot1x mac-session
<mac-address> “Clearing a dot1x-mac-session for a MAC address” on
page 1064
clear dot1x statistics all I
<portnum> “Clearing 802.1x statistics” on page 1068
dot1x filter-strict-security “Disabling and enabling strict security mode for
dynamic filter assignment” on page 1056
dot1x initialize
<portnum> “Initializing 802.1x on a port” on page 1063
dot1x port-control [force-authorized | force-unauthorized |
auto]
“Setting the port control” on page 1059