Configuration Guide User guide

BigIron RX Series Configuration Guide 1455
53-1002484-04
Security/Management
E
Access
dot1x re-authenticate <portnum> “Re-authenticating a port manually” on page 1061
dot1x-enable “Enabling 802.1x port security” on page 1059
enable all I
<portnum> [to <portnum> ] “Enabling 802.1x port security” on page 1059
global-filter-strict-security “Disabling and enabling strict security mode for
dynamic filter assignment” on page 1056
maxreq
<value> “Specifying the number of EAP-request/identity
frame retransmissions” on page 1062
radius-server host
<ip-addr> | <server-name> [auth-port
<number> acct-port <number> [authentication-only |
accounting-only | default [key 0 | 1
<string> [dot1x]]] ]
“Setting RADIUS parameters” on page 1053
re-authentication “Configuring periodic re-authentication” on
page 1060
servertimeout
<seconds> “Specifying a timeout for retransmission of messages
to the authentication server” on page 1062
show dot1x “Displaying 802.1x configuration information” on
page 1064
show dot1x config ethernet
<slot/port> “Displaying 802.1x configuration information” on
page 1064
show dot1x ip-acl [all | ethernet
<slot/port> | | begin
<expression> | exclude <expression> | include
<expression>]
“Displaying IP ACLs applied to an 802.1x-enabled
port” on page 1070
show dot1x mac-address-filter [all | ethernet
<slot/port>
[begin
<expression> | exclude <expression> | include
<expression>]]
“Displaying MAC address filters applied to an
802.1x-enabled port” on page 1069
show dot1x mac-session [brief [begin
<expression> |
exclude
<expression> | include <expression>]]
“Displaying information about the
dot1x-mac-sessions on each port” on page 1070
“Displaying information about the ports in an 802.1x
multiple client configuration” on page 1071
show dot1x statistics [all | ethernet <slot/port>] “Displaying 802.1x statistics” on page 1067
supptimeout
<seconds> “Specifying a timeout for retransmission of
EAP-request frames to the client” on page 1062
timeout quiet-period
<seconds> “Setting the quiet period” on page 1061
timeout re-authperiod
<seconds> “Configuring periodic re-authentication” on
page 1060
timeout tx-period
<seconds> “Setting the interval for retransmission of
EAP-request/ identity frames” on page 1061
Commands See ...
all-client <ip-addr> “Restricting all remote management access to a
specific IP address” on page 60
Commands See ...