Configuration Guide User guide

1462 BigIron RX Series Configuration Guide
53-1002484-04
Redundant management module
E
Redundant management module
Commands See ...
active-management <mgt-module> “Changing the default active slot” on page 21
sync-standby “Comparing and synchronizing files” on page 23
force-sync-standby “Synchronizing files without comparison” on page 24
switchover “Manually switching over to the standby
management module” on page 24
reset “Manually switching over to the standby
management module” on page 24
boot system bootp | [flash primary | flash secondary] |
slot
<number> <filename> | tftp <ip-address>
<filename>
“Rebooting the active and standby management
modules” on page 24
reload “Rebooting the active and standby management
modules” on page 24
reboot-standby “Rebooting the active and standby management
modules” on page 24
show module “Determining management module status” on
page 25
show chassis “Displaying temperature information” on page 26
format slot1 | slot2 “Formatting a flash card” on page 32
pwd “Determining the current management focus” on
page 33
cd
<directory-pathname> “Switching the management focus” on page 33
chdir
<directory-pathname> “Switching the management focus” on page 33
dir | ls [
<path-name>] “Displaying a directory of the files” on page 34
more [/
<directory>/]<file-name> “Displaying the contents of a file” on page 36
hd [/
<directory>/]<file-name> “Displaying the hexadecimal output of a file” on
page 37
md | mkdir [slot1 | slot2]
<dir-name> “Creating a subdirectory” on page 37
rd | rmdir [slot1 | slot2]
<dir-name> “Removing a subdirectory” on page 39
rename | mv [/
<directory>/]<old-file-name>
[/
<directory>/]<new-file-name>
“Renaming a file” on page 40
attrib [slot1 | slot2] ro | rw
<file-name> “Changing the read-write attribute of a file” on
page 40
delete | rm [slot1 | slot2] [
<directory>] [<file-name>] “Deleting a file” on page 41
undelete “Recovering (“undeleting”) a file” on page 42
append [
<source-file-system> <dest-file-system>]
[/
<source-dir-path>/]<source-file-name>
[/
<dest-dir-path>/]<dest-file-name>
“Appending a file to another file” on page 43
copy
<from-card> <to-card>
[/
<from-dir-path>/]<from-name>
[/
<to-dir-path>/][<to-name>]
“Copying files using the copy command” on page 43