Configuration Guide User guide

1466 BigIron RX Series Configuration Guide
53-1002484-04
STP
E
STP
SysLog messages
Commands See ...
show spanning-tree [vlan <vlan-id>] | [pvst-mode] |
[
<num>] |
[detail [vlan
<vlan-id> [ethernet <slot/port> ] [|
begin
<expression> | exclude<expression> |
include
<expression>]
“Displaying STP information for an entire device” on
page 334
show spanning-tree detail [vlan
<vlan-id> [ethernet
<slot/port>]]
“Displaying detailed STP information for each
interface” on page 336
show xstp ethernet
<slot/port> “Displaying STP information for the specified
Ethernet interface” on page 339
spanning-tree [ethernet
<slot/port>] [forward-delay
<value>] | [hello-time <value>] | [max-age <value>] |
[priority
<value>]
“Changing STP bridge parameters” on page 329
spanning-tree ethernet
<portnum> path-cost <value> |
priority
<value> | disable | enable
“Changing STP port parameters” on page 330
spanning-tree single [ethernet
<portnum> path-cost
<value> | priority <value>]
“Enabling SSTP” on page 343
spanning-tree single [forward-delay
<value>] [hello-time
<value>] | [maximum-age <time>] | [priority <value>]
“Enabling SSTP” on page 343
spanning-tree “Enabling or disabling STP globally” on page 328
“Enabling or disabling STP on a VLAN” on page 328
“Enabling or disabling STP on a port” on page 328
Commands See ...
clear logging [dynamic-buffer | static-buffer] “Displaying the Syslog configuration” on page 1381
“Clearing log entries” on page 1383
Ip show-portname “Displaying the interface name in Syslog messages”
on page 1388
ip show-service-number-in-log “Syslog messages” on page 1389
logging buffered
<level> | <num-entries> “Disabling logging of a message level” on page 1386
“Changing the number of entries the local buffer can
hold” on page 1387
logging console “Enabling real-time display of Syslog messages” on
page 1380
logging facility
<facility-name> “Changing the log facility” on page 1387
logging host
<ip-addr> | <server-name> “Specifying a Syslog server” on page 1385
“Specifying an additional Syslog server” on
page 1385
logging on [
<udp-port>] “Disabling or re-enabling Syslog” on page 1385