Configuration Guide User guide

1468 BigIron RX Series Configuration Guide
53-1002484-04
Topology
E
Topology
snmp-server enable traps
<trap-type>
“Disabling SNMP traps” on page 122
snmp-server enable traps holddown-time
<secs> “Setting the SNMP Trap holddown time” on page 122
snmp-server host
<ip-addr> [0 | 1] <string> [port
<value>]
“Specifying an SNMP trap receiver” on page 121
snmp-server location
<string> “Entering system administration information” on
page 120
snmp-server trap-source loopback
<num> | ethernet
<slot/port> | ve <num>
“Specifying a Single trap source” on page 121
sntp poll-interval
<1-65535> “Specifying a Simple Network Time Protocol (SNTP)
server” on page 127
sntp server
<ip-addr> | <hostname> [<version>] “Specifying a Simple Network Time Protocol (SNTP)
server” on page 127
static-mac-address
<mac-addr> ethernet <portnum> [to
<portnum> ethernet <portnum>]
[priority
<number>] [host-type | router-type | fixed-host]
“Assigning static MAC address entries to priority
queues” on page 485
system-max ip-static-route
<num> “Displaying and modifying system parameter default
settings” on page 133
system-max subnet-per-interface
<num> “Displaying and modifying system parameter default
settings” on page 133
system-max subnet-per-system
<num> “Displaying and modifying system parameter default
settings” on page 133
terminal length
<number-of-lines> “Configuring terminal display” on page 132
unknown-unicast limit
<number> “NP based multicast, broadcast, and
unknown-unicast rate limiting” on page 519
Commands See ...
Commands See ...
master-vlan <vlan-id> “Configuring a topology group” on page 453
member-group
<num> “Configuring a topology group” on page 453
member-vlan
<vlan-id> “Configuring a topology group” on page 453
show topology-group [
<group-id>] “Displaying topology group information” on page 454
topology-group
<group-id> “Configuring a topology group” on page 453