Configuration Guide User guide

BigIron RX Series Configuration Guide 491
53-1002484-04
Displaying QoS mapping information
18
Displaying QoS mapping information
To display Quality of Service (QoS) mapping information, enter the following command.
BigIron RX# show qos-maps
Policed-dscp map: (dscp = d1d2)
d2| 0 1 2 3 4 5 6 7 8 9
d1 |
-----+------------------------------------------------
0 | 0 1 2 3 4 5 6 7 8 9
1 | 10 11 12 13 14 15 16 17 18 19
2 | 20 21 22 23 24 25 26 27 28 29
3 | 30 31 32 33 34 35 36 37 38 39
4 | 40 41 42 43 44 45 46 47 48 49
5 | 50 51 52 53 54 55 56 57 58 59
6 | 60 61 62 63
Dscp-cos map: (dscp = d1d2)
d2| 0 1 2 3 4 5 6 7 8 9
d1 |
TABLE 100 ToS-based QoS configuration information
This field... Displays...
Interface QoS, marking and trust level information
i/f The interface
QoS The state of ToS-based QoS on the interface. The state can be one of
the following:
• No – Disabled
• Yes – Enabled
Mark The marking type enabled on the interface. The marking type can be
any of the following:
• COS – CoS marking is enabled.
• DSCP – DSCP marking is enabled.
• No – Marking is not enabled.
Trust-Level The trust level enabled on the interface. The trust level can be one of
the following:
• DSCP
• L2 CoS
CoS-DSCP map
COS The CoS (802.1p) values.
dscp The DSCP values to which the device maps the CoS values above.
DSCP-priority map
d1 and d2 The DSCP -> forwarding priority mappings that are currently in effect.
DSCP-DSCP map
d1 and d2 The DSCP -> DSCP mappings that are currently in effect.
CoS-priority map The CoS (802.1p) forwarding priority mapping that is currently in effect.