Configuration Guide User guide

lxiv BigIron RX Series Configuration Guide
53-1002484-04
Enhancements in patch release 02.3.00a
Syslog Source Interface You can configure the BigIron RX to use the
lowest-numbered IP or IPv6 address configured on
a loopback interface, virtual interface, or Ethernet
port as the source for all Syslog packets from the
device.
Book: BigIron RX Series
Configuration Guide
Chapter: “Configuring IP”
Section:“Configuring an
interface as the source for
Syslog packets”
UDLD Traps and Syslogs UDLD state changes will now be logged by default. Book: MIB Reference
Chapter: Traps and Objects
to Enable Traps
Section: UDLD Traps
New Brocade MIB objects The following MIBs have been depreciated by
snAgentCpuUtilTable:
• snAgGblCpuUtil1SecAvg
• snAgGblCpuUtil5SecAvg
• snAgGblCpuUtil1MinAvg
Book: MIB Reference
Chapter: Monitoring and
Logging
Section: Usage Notes on
CPU Utilization and System
CPU Utility Table
TABLE 15 Summary of enhancements in patch release 02.3.00a
Enhancement Description See...
Transparent Port Flooding When the Transparent Port Flooding feature in
enabled for a port, all MAC learning will be disabled
for that port. This will result in all Layer 2 traffic to
be flooded to all other ports within the VLAN.
Starting with release 02.3.00a.
Book: BigIron RX Series
Configuration Guide
Chapter: “Using the MAC
Port Security Feature
and Transparent Port Flo
oding”
Section:“Transparent
port flooding”
VLAN ID to MSTP Instance
Pre-assignment
This feature will allow the user to assign a VLAN ID
to a Common Spanning Tree (CIST), or Multiple
Spanning Tree Instance (MSTI) even though a VLAN
has not been created yet. Starting with release
02.3.00a.
Book: BigIron RX Series
Configuration Guide
Chapter: “Multiple
Spanning Tree Protocol
(MSTP) 802.1s” and
“VLANs”
Section:“Configuring an
MSTP instance”
TABLE 14 Summary of enhancements in release 02.4.00 (Continued)
Enhancement Description See page