Configuration Guide User guide

616 BigIron RX Series Configuration Guide
53-1002484-04
Displaying ACL definitions
22
Enter all to display all of the ACLs configured on the device.
Named ACL
For a named ACL, enter a command such as the following.
BigIron RX(config)#show access-list name entry
Standard IP access list entry
deny host 5.6.7.8
deny host 192.168.12.3
permit any
Syntax: show access-list name <acl-name>
Enter the ACL name for the <acl-name> parameter or the ACL number for <acl-number>.
Displaying of TCP/UDP numbers in ACLs
You can display the port numbers of TCP/UDP application information instead of their TCP/UDP
well-known port name in the output of show commands and other commands that contain
application port information. For example, entering the following command causes the device to
display 80 (the port number) instead of http (the well-known port name).
BigIron RX(config)# ip show-acl-service-number
Syntax: [no] ip show-acl-service-number
By default, the device displays TCP/UDP application information in named notation.
The following table lists the ports by number and well-known name.
TABLE 114 TCP/UDP port numbers and names
Port service
number
Port name Description
1 tcpmux TCP Port Service Multiplexer
2 compressnt-2 Management Utility
3 compressnt-3 Compression Process
5rje Remote Job Entry
11 systat Active Users
13 daytime Daytime (RFC 867)
17 qotd Quote of the Day
18 msp Message Send Protocol
19 chargen Character Generator
20 ftp-data File Transfer [Default Data]
21 ftp File Transfer [Control]
22 ssh SSH Remote Login Protocol
23 telnet Telnet
25 smtp Simple Mail Transfer
27 nsw-fe NSW User System FE