Configuration Guide User guide

802 BigIron RX Series Configuration Guide
53-1002484-04
Displaying OSPF information
26
Syntax: show ip ospf routes [<ip-addr>]
The <ip-addr> parameter specifies a destination IP address. If you use this parameter, only the
route entries for that destination are shown.
This display shows the following information.
Displaying the routes that have been redistributed into OSPF
You can display the routes that have been redistributed into OSPF. To display the redistributed
routes, enter the following command at any level of the CLI.
TABLE 128 CLI display of OSPF route information
This field... Displays...
Destination The IP address of the route's destination.
Mask The network mask for the route.
Path_Cost The cost of this route path. (A route can have multiple paths. Each path
represents a different exit port for the device.)
Type2_Cost The type 2 cost of this path.
Path_Type The type of path, which can be one of the following:
• Inter – The path to the destination passes into another area.
• Intra – The path to the destination is entirely within the local area.
• External1 – The path to the destination is a type 1 external route.
• External2 – The path to the destination is a type 2 external route.
Adv_Router The OSPF router that advertised the route to this device.
Link-State The link state from which the route was calculated.
Dest_Type The destination type, which can be one of the following:
• ABR – Area Border Router
• ASBR – Autonomous System Boundary Router
• Network – the network
State The route state, which can be one of the following:
• Changed
• Invalid
• Valid
This information is used by Brocade technical support.
Tag The external route tag.
Flags State information for the route entry. This information is used by Brocade
technical support.
Paths The number of paths to the destination.
Out_Port The router port through which the device reaches the next hop for this
route path.
Next_Hop The IP address of the next-hop router for this path.
Type The route type, which can be one of the following:
• OSPF
• Static Replaced by OSPF
State State information for the path. This information is used by Brocade
technical support.