Administrator's Guide (Supporting 300, 5100, 5300, 6505, 6510, 6520, 7800, 7840, and VA-40FC) Instruction Manual

management tool for this switch, you must discover it again with EZSwitchSetup and select
the first continuation option.
• Exit EZSwitchSetup
Select this option if you want to use EZSwitchSetup as an IP configuration tool, but do not
want to use EZSwitchSetup Switch Manager as a management tool for the switch.
FIGURE 11 Continue Configuration window
3. Click Continue.
Depending on the option selected, one of the following outcomes occurs:
• If you selected Continue setting up your target switch with EZManager, a dialog box
displays warning you that EZSwitchSetup supports only single-switch fabrics. Click OK to
start the EZSwitchSetup Switch Manager.
A browser window opens, and the Switch Configuration Welcome window is displayed
(Figure 12 on page 26). This may take a few minutes.
If the EZSwitchSetup switch configuration wizard does not launch, you must launch it
manually by specifying the URL in a browser:
http://switch-ip-address
Setting Up Your Switch
24 EZSwitchSetup Administrator’s Guide
53-1003129-01