Reference (Supporting Fabric OS v7.3.0) Owner manual

452 Fabric OS Command Reference
53-1003131-01
fwMailCfg
2
fwMailCfg
Displays and configures Fabric Watch email alerts.
SYNOPSIS fwmailcfg
DESCRIPTION Use this command to display or modify the configuration and status of the Fabric Watch email alert on
the switch.
Switch elements monitored by Fabric Watch are divided into classes, and e-mail alerts are based on the
classes. Each class can configure up to five e-mail addresses as the alert message's receiver. Multiple
e-mail addresses must be separated by a comma. The e-mail addresses must conform to standard
syntax [e-mail]. Default domains are not automatically appended. Invalid e-mail addresses
are rejected. "NONE" is the default address and a valid input parameter.
In Access Gateway mode, only the following classes are supported.
• Environment class
• SFP class
• Port class
• F/FL Port (Optical) class
• F/FL Port (Copper) class (embedded platforms only)
• Resource class
For an e-mail alert to function correctly, add the CP0 and CP1 IP addresses and host names to DNS and
also set the domain name and name server. The ipAddrShow and dnsConfig commands can be used
to set and verify this information.
NOTES This command requires a Fabric Watch license.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS None
EXAMPLES To configure email settings:
switch:admin> fwmailcfg
1 : Show Mail Configuration Information
2 : Disable Email Alert
3 : Enable Email Alert
4 : Send Test Mail
5 : Set Recipient Mail Address for Email Alert
6 : Relay Host IP Configuration
7 : Quit
Select an item => : (1..7) [7]1
Config Show Menu
--------------------------------------
1 : Environment class
2 : SFP class
3 : Port class
4 : Fabric class
5 : E-Port class
6 : F/FL Port (Optical) class
7 : Alpa Performance Monitor class
8 : End-to-End Performance Monitor class