Reference (Supporting Fabric OS v7.3.0) Owner manual

504 Fabric OS Command Reference
53-1003131-01
ipAddrSet
2
-cp cp_number
Specifies the CP on a chassis. Valid values are 0 or 1.
-chassis
Specifies the IPv6 address and prefix of a chassis.
On platforms with blade processors, the following additional command line
options are supported with the --add or --delete options:
-eth0 | -eth1
Specifies the local IPv4 address of the blade processor. A prefix is required.
-gate
Specifies the IPv4 address of the blade processor (BP) Gateway (no prefix).
-slot number
On a chassis with a blade processor (BP), specifies the slot number. On
standalone platforms with a hidden BP, such as the AP76500, this parameter is
not accepted.
-ipv6 [-auto | -noauto]
Enables or disables stateless IPv6 autoconfiguration on a switch or chassis.
When autoconfiguration is enabled, the host automatically performs configuration
of IPv6 addresses and periodic nondisruptive reconfiguration. By default,
autoconfiguration is disabled.
-ls FID
Specifies the logical fabric ID for which to configure an IPFC network interface.
The FID is a decimal number. A switch that is not in Virtual Fabric mode uses the
-ls parameter with FID 128 (the effective, single Logical Fabric number on such
switches) to set the IPv4 FC address. Note that setting the IP address for the
logical switch is only for the IPFC interface, not for the Ethernet interface.
--add
Assigns a specified IPv4 FC address and prefix to the logical switch instance
represented by the specified FID. This command replaces any existing FC
IPv4 address.
IPv4_address/prefix
Specifies the IPv4 address and prefix for the IPFC network interface. The IP
Address is represented by a dotted decimal number, followed by a slash and
a prefix. This operand is required with the --add option.
--delete
Deletes the IPv4 FC address and prefix from a logical switch.
-ls IFID
Specifies the fabric ID that identifies the logical switch for which to delete the
FC IPv4 address and prefix. This operand is required when deleting an FC
IPv4 address from a logical switch. On a switch that is not in Virtual Fabric
mode, use the -ls parameter with FID 128 (the effective, single Logical Fabric
number on such switches) to delete the IPv4 FC address.
When used interactively to configure IPv4 addresses on a modular platform, ipAddrSet prompts for the
following parameters:
-cp cp_number
Specifies the managed entity as a CP. Valid values include the following:
0
Sets the Ethernet IP address, Ethernet subnet mask, gateway IP address and
host name of CP0.