Administrators Guide (Supporting Fabric OS v7.3.0) User Manual

Number of supported NPIV devices (Continued)TABLE 81
Platform Virtual Fabrics Logical switch type NPIV support
DCX-4S and
DCX 8510-4
Enabled Default switch Yes, 255 virtual device limit.
DCX-4S and
DCX 8510-4
Enabled Logical switch Yes, 255 virtual device limit.
19
DCX-4S and
DCX 8510-4
Enabled Base switch No.
Configuring NPIV
The NPIV feature is enabled by default. You can set the number of virtual N_Port IDs per port to a value
from 1 through 255 per port. The default setting is 126.
The portCfgNPIVPort command is used to specify the maximum number of virtual N_port IDs per port
on a switch. It can also be used to enable or disable NPIV. Once NPIV is enabled on the port, you can
specify the number of logins per port. If the NPIV feature has been disabled, then the NPIV port
configuration does not work.
The addressing mode can limit the maximum number of NPIV logins to 127 or 63 depending on the
mode. The portCfgNPIVPort command can set the maximum number of NPIV logins limit to anything
from 1 through 255, regardless of the addressing mode. Whichever of these two (addressing mode or
the value configured through portCfgNPIVPort) is lower will be the maximum number that can be
logged in.
CAUTION
The portDisable command disables the port and stops all traffic flowing to and from the port.
Use this command during a scheduled maintenance.
1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the portDisable command.
3. Enter the portCfgNPIVPort --setloginlimit command with the port number and the number of logins
per port.
4. Enter the portEnable command to enable the port.
switch:admin> portcfgnpivport --setloginlimit 7/0 128
NPIV Limit Set to 128 for Port 128
switch:admin> portcfgshow 7/0
Area Number: 128
Octet Speed Combo: 1(16G|8G|4G|2G)
Speed Level: AUTO(SW)
AL_PA Offset 13: OFF
Trunk Port ON
Long Distance OFF
VC Link Init OFF
Locked L_Port OFF
Locked G_Port OFF
Disabled E_Port OFF
Locked E_Port OFF
ISL R_RDY Mode OFF
RSCN Suppressed OFF
Persistent Disable OFF
LOS TOV enable OFF
Configuring NPIV
Fabric OS Administrators Guide 441
53-1003130-01