Administrators Guide (Supporting Fabric OS v7.3.0)

FOP_Port and FCU_Port subclass default settings (Continued)TABLE 18
Area Description Default threshold
settings
Default alarm
settings
Threshold state
Link reset Monitors the number of link
resets sent by a given port
(LR-Out) and received on a
given port (LR-In).
Unit: Errors
Time Base: minute
Low: 0
High: 500
Buffer: 50
Below: 0
Above: 0
Informative
Out_of_range
VE_Port class default settings
NOTE
Only a subset of areas can be configured for the VE_Port class. When setting VE_Port thresholds for
the Packet Loss area, the threshold value accepts up to two decimal points; for example: -value 0.60,
as shown in Packet loss monitoring enhancements on the VE_Port on page 78.
VE_Port class default settingsTABLE 19
Area Description Default threshold settings Default alarm
settings
Threshold state
Packet loss The number of packets
routed through a port
exceeds the port
bandwidth.
Unit: Errors
Time Base: minute
Low: 0
High: 10
Buffer: 0
Below: 0
Above: 0
Informative
Out_of_range
State changes
(ST)
Monitors state changes. Unit: Changes
Time Base: minute
Low: 0
High: 50
Buffer: 0
Below: 0
Above: 0
Informative
Out_of_range
Utilization The percent of utilization
for the port at the time of
the last poll.
Unit: Errors
Time Base: minute
Low: 0
High: 100
Buffer: 0
Below: 0
Above: 0
Informative
Out_of_range
Packet loss monitoring enhancements on the VE_Port
Fabric Watch provides monitoring for packet loss percentage for the VE_Port. Previously, configuring
the packet loss percentage for the VE_Port was allowed as a whole number; however, packet loss is
VE_Port class default settings
78 Fabric Watch Administrators Guide
53-1003142-01