Software Upgrade Guide Manual

Modified OSPFv2 commands (Continued)TABLE 5
FastIron 08.0.xx FastIron 07.4.00 Note
[no] timers throttle spf
delay hold-time max-hold
timers spf delay hold-time
FastIron 07.4.00:
delay corresponds to delay between receiving a
change to SPF calculation. The valid range is 0 to
65535.
hold-time corresponds to hold time between
consecutive SPF calculations. The valid range is 0
to 65535.
FastIron 08.0.xx:
delay corresponds to initial delay (milliseconds)
between receiving a change to SPF, valid range is
0-60000.
hold-time corresponds to hold time (milliseconds)
between two SPF calculations. Default is 0 and valid
range is 0-60000.
max-hold corresponds to max hold time
(milliseconds) between two SPF calculations.
Default is 0 and valid range is 0-60000.
default-information-
originate always
default-information-
originate
In FastIron 07.4.00 release, the default-
information-originate always command was
enough to originate default route irrespective of any
static or dynamic default route present on the router.
However, in FastIron 08.0.xx, if no default route is
present on the router, then you are required to use
the default-information-originate always
command.
distribute-list [standard-ip-
access-list | extended-ip-
access-list | access-list-
name | route-map route-
map-name ] in
distribute-list [standard-
ip-access-list | extended-
ip-access-list | access-
list-name] in [ethernet |
ve]
In FastIron 08.0.xx release, the distribute-list is
applied to all interfaces. Also, you can configure the
OSPF distribution using route map as input.
Show command
show ip ospf area ip-addr
database link-state nssa
link-id adv-router router-id
show ip ospf area ip-
addr database link-state
nssa
In FastIron 08.0.xx, you can display the link state for
specific advertising router.
show ip ospf virtual link show ip ospf virtual-
links
Displays OSPF virtual link information.
show ip ospf virtual
neighbor
show ip ospf virtual-
neighbor
Displays OSPF virtual neighbour information.
Clear command
clear ip ospf route clear ospf route
Clears all or specific OSPF route.
Upgrade and downgrade considerations
16 FastIron Ethernet Switch Software Upgrade Guide
53-1003089-02