Software Upgrade Guide Manual

Modified RIP commands TABLE 10
FastIron 08.0.xx FastIron 07.4.00 Note
Global level command (router RIP and sub-command)
[no] redistribute connected |
bgp | ospf | static [metric
value | route-map name]
[no] redistribution
Redistributes routes from other routing
protocols.
[no] prefix-list name in | out filter filter-num permit | deny
source-ip-address | any source-
mask | any [log]
Specifies the prefix list as route map to
filter out specific routes.
[no] timers seconds update-time 1-1000
Configures timer to set how often should
RIP send updates. This command is
added for backward compatibility.
Interface level command
[no] ip rip metric-offset num
in | out
ip metric 1-16
ip metric is not supported. Since ip
metric was used to modify RIP metric, it
is changed to ip rip metric-offset. It is
added for backward compatibility only.
[no] ip rip prefix-list name in |
out
[no] ip rip filter-group in |
out filter-list
Specifies the prefix list as route map to
filter out specific routes.
Deprecated RIP commands TABLE 11
Command Note
Global level command (router RIP and sub-command)
[no] offset-list ACL-number-or-name in | out offset
[ethernet port]
Instead, the route-map or prefix-list command
can be used.
[no] permit | deny redistribute filter-num all | bgp | ospf
| static address ip-addr ip-mask [match-metric value |
set-metric value]
Instead, the route-map command can be used.
[no] dont-advertise-connected
Connected routes are not redistributed by default
in FastIron 08.0.xx.
BGP and Route-Map
Modified BGP commands TABLE 12
FastIron 08.0.xx FastIron 07.4.00 Note
Clear command
BGP and Route-Map
FastIron Ethernet Switch Software Upgrade Guide 19
53-1003089-02