Hardware Installation Guide Owner's manual

The power supplies comply with the conducted and radiated test, immunity, and safety standards as
listed in the table below. EMC standards are within a 6 dB minimum margin.
Power supply regulatory complianceTABLE 39
Description Certifications
Electromagnetic
Emissions
CISPR 22 Class A
FCC Class A
VCCI Class A
EN55022 Class A
Harmonic Current Emissions (Class A) - EN61000-3-2, with Amendment 14 (1999)
Voltage Fluctuations and Flicker - EN61000-3-3
ICES-003 Class A
AS/NZS 3548 Class A
Immunity EN 55024
EN 61000-4-5. The power supply is tested to level 2 (differential mode) and level 3
(common mode)
Safety UL 60950-1/CSA C22.2 No 60950-1-03 - Safety of Information Technology Equipment
EN 60950-1 - Safety of Information Technology Equipment
IEC 60950-1 - Safety of Information Technology Equipment
Safety warnings
The power supplies are marked with an electrical hazard label and with the safety warnings shown in
the table below.
Safety warning labels on power suppliesTABLE 40
CAUTION: No operator serviceable parts inside. Refer servicing to qualified personnel.
ATTENZIONE Non aprire. Rivolgersi a personale qualificado.
CUIDADO Partes adentro no reparables por el operador. Refiera reparo a personal autorizado.
ATTENTION Entretien et répartions internes ne sont autorisés qu’au personnel technique qualifié.
GEFAHR Zugang zur Bedienung nicht erförderlich. Wartung nur durch qualifiziertes Personal.
The SX-ACPWR-SYS with part number 32014-xxx and SX-ACPWR-POE with part number 32016-xxx ,
have additional safety warning labels as shown in the table below.
Safety warnings
Brocade FastIron SX Series Chassis Hardware Installation Guide 169
53-1003092-01