Hardware Installation Guide Owner's manual

• 24 10/100/1000 copper ports
• 24 LEDs for port status
• 24 LEDs for PoE status
LEDs for 24-port copper module with PoE+
The front panel of the 24-port Gigabit Ethernet copper module includes 24 LEDs (top) that indicate the
status of each port, and 24 LEDs (bottom) that indicate the PoE status.
The copper ports provide status information using the LEDs described in the table below.
LEDs for 10/100/1000 copper ports TABLE 10
LED Position State Meaning
Link or Activity Square LED located at upper left corner of to
port (for top port)
Square LED located at upper right corner of top
port (for bottom port)
On (Green) A link is established with the
remote port.
Blinking The port is transmitting and
receiving traffic.
Off No link exists with the
remote port.
PoE or PoE+(if
applicable)
Round LED located beneath the ports. The first
(left-most) LED is for port 1, the second LED is
for port 2, the third LED is for port 3, etc.
On (Green) The port is enabled, a
power-consuming device
has been detected, and the
module is supplying power
to the device.
Off The port is not providing in-
line power.
Hardware features
34 Brocade FastIron SX Series Chassis Hardware Installation Guide
53-1003092-01