Configuration Guide User guide

1080 FastIron Configuration Guide
53-1002494-02
Displaying IP configuration information and statistics
Displaying IP information – Layer 2 Switches
You can display the following IP configuration information statistics on Layer 2 Switches:
• Global IP settings – refer to “Displaying global IP configuration information” on page 1080.
• ARP entries – refer to “Displaying ARP entries” on page 1081.
• IP traffic statistics – refer to “To display IP traffic statistics on a Layer 2 Switch, enter the show
ip traffic command at any CLI level.” on page 1082.
Displaying global IP configuration information
To display the Layer 2 Switch IP address and default gateway, enter the show ip command.
Syntax: show ip
This display shows the following information.
resp from
loopback
The number of RIP responses received from loopback interfaces.
packets
rejected
This information is used by Brocade customer support.
TABLE 189 CLI display of global IP configuration information – Layer 2 Switch
Field Description
IP configuration
Switch IP address The management IP address configured on the Layer 2 Switch. Specify this
address for Telnet or Web management access.
Subnet mask The subnet mask for the management IP address.
Default router address The address of the default gateway, if you specified one.
Most recent TFTP access
TFTP server address The IP address of the most-recently contacted TFTP server, if the switch has
contacted a TFTP server since the last time the software was reloaded or the
switch was rebooted.
TABLE 188 CLI display of IP traffic statistics – Layer 3 Switch (Continued)
Field Description
Brocade# show ip
Switch IP address: 192.168.1.2
Subnet mask: 255.255.255.0
Default router address: 192.168.1.1
TFTP server address: None
Configuration filename: None
Image filename: None