Configuration Guide User guide

1094 FastIron Configuration Guide
53-1002494-02
Standard STP parameter configuration
To view STP Protection configuration for a specific port, enter the following command at any level of
the CLI.
If you enter the show stp-protect command for a port that does not have STP protection enabled,
the following message displays on the console.
Syntax: show stp-protect [ethernet <port>]
Specify the port variable in one of the following formats:
• FWS, FCX, and ICX stackable switches – stack-unit/slotnum/portnum
• FSX 800 and FSX 1600 chassis devices – slotnum/portnum
• ICX devices – slotnum/portnum
• FESX compact switches – portnum
Displaying STP information
You can display the following Spanning Tree Protocol (STP) information:
• All the global and interface STP settings
• CPU utilization statistics
• Detailed STP information for each interface
• STP state information for a port-based VLAN
• STP state information for an individual interface
Brocade#show stp-protect
Port ID BPDU Drop Count
3 478
5 213
6 0
12 31
Brocade#show stp-protect e 3
STP-protect is enabled on port 3. BPDU drop count is 478
Brocade#show stp-protect e 4
STP-protect is not enabled on port 4.