Configuration Guide User guide

FastIron Configuration Guide 1191
53-1002494-02
Modifying and displaying Layer 3 system parameter limits
• Number of hardware logical interfaces (physical port and VLAN pairs) – This value is the same
as the maximum number of VLANs supported systemwide, so it is not configurable nor
displayed in the show default value output in second generation modules.
• Number of multicast output interfaces (clients) – 3072 maximum. This value is fixed in second
generation modules and cannot be modified. This system parameter occupies its own
hardware memory space.
To display the current settings for the Layer 3 system parameters, use the show default value
command. Refer to “Displaying Layer 3 system parameter limits” on page 1191.
FastIron third generation modules
The default value of next hop entries on FastIron X Series devices with the following third
generation modules installed is 16384. This value is predefined and not editable.
• SX-FI48GPP
• SX-FI-2XG
• SX-FI-8XG
• SX-FI-24HF
• SX-FI-24GPP
If the FastIron X Series device is installed with first generation or second generation modules, the
system automatically calculates the default value for these modules.
Displaying Layer 3 system parameter limits
To display the Layer 3 system parameter defaults, maximum values, and current values, enter the
show default value command at any level of the CLI.
The following example shows output on a FastIron X Series with first generation modules.
Brocade#show default value
sys log buffers:50 mac age time:300 sec telnet sessions:5
ip arp age:10 min bootp relay max hops:4 ip ttl:64 hops
ip addr per intf:24
igmp group memb.:140 sec igmp query:60 sec
ospf dead:40 sec ospf hello:10 sec ospf retrans:5 sec
ospf transit delay:1 sec
System Parameters Default Maximum Current
ip-arp 4000 64000 4000
ip-static-arp 512 1024 512
some lines omitted for brevity....
hw-ip-next-hop 2048 6144 2048
hw-logical-interface 4096 4096 4096
hw-ip-mcast-mll 1024 4096 1024