Configuration Guide User guide

94 FastIron Configuration Guide
53-1002494-02
Diagnostic error codes and remedies for TFTP transfers
This section describes the error messages associated with the TFTP transfer of PoE firmware file to
a Brocade device.
7 TFTP busy, only one TFTP
session can be active.
Another TFTP transfer is active on another CLI session, or Web
management session, or network management system.
Wait, then retry the transfer.
8 File type check failed. You accidentally attempted to copy the incorrect image code into the
system. For example, you might have tried to copy a Chassis image into
a Compact device.
Retry the transfer using the correct image.
16 TFTP remote - general error. The TFTP configuration has an error. The specific error message
describes the error.
Correct the error, then retry the transfer.
17 TFTP remote - no such file.
18 TFTP remote - access violation.
19 TFTP remote - disk full.
20 TFTP remote - illegal operation.
21 TFTP remote - unknown
transfer ID.
22 TFTP remote - file already
exists.
23 TFTP remote - no such user.
Message Explanation and action
Firmware TFTP timeout. TFTP failed because of a time out.
Check IP connectivity and make sure the TFTP server is running.
Firmware is not valid for this
platform.
TFTP failed because the specified file is not found on the TFTP server.
Firmware is not valid for the
IEEE 802.3at (PoE-Plus)
controller type.
Each PoE firmware file delivered by Brocade is meant to be used on the
specific platform only. If the file is used on a platform for which it is not
meant, then this error message will display.
Download the correct file, then retry the transfer.
Firmware is not valid for the
IEEE 802.3af PoE controller
type.
Firmware type cannot be
detected from the firmware
content.
Each PoE firmware file delivered by Brocade is meant to be used on the
specific platform and the specific PoE controller on the specified
module. If the file is used for a platform for which it is meant, but the
PoE controller is not same then this error message will display.
Download the correct file, then retry the transfer.
TFTP File not Valid for PoE
Controller Type.
Firmware tftp remote file
access failed.
The TFTP server needs read access on the PoE firmware file. Check the
permissions on the file, then try again.
Error
code
Message Explanation and action