Configuration Guide User guide

1554 FastIron Configuration Guide
53-1002494-02
PIM Sparse
Syntax: show ip pim | dvmrp rpf <IP address>
where <IP address> is a valid source IP address.
NOTE
If there are multiple equal cost paths to the source, the show ip pim rpf command output may not
be accurate. If your system has multiple equal cost paths, use the command show ip pim mcache
to view information about the upstream neighbor.
Displaying the PIM flow cache
To display the PIM flow cache, enter the following command at any CLI level.
Syntax: show ip pim flowcache
In the above output of the show ip pim flowcache command, ethe 3/14is the outbound interface
on which the multicast traffic is being sent out.
Brocade #show ip pim flowcache 228.2.2.2
Outbound Ports for Multicast flow (12.12.12.1 228.2.2.2):
L2 : None
L3 :
Tagged Port in VLan 1 : ethe 3/14
Outbound Ports for Multicast flow (0.0.0.0 228.2.2.2):
L2 : 8192
Hardware MC Entry not found
2 flow printed