Configuration Guide User guide

ManualsBrandsBrocade ManualsComputer AccessoriesFastIron

1621

1570 FastIron Configuration Guide

53-1002494-02

Multicast Source Discovery Protocol (MSDP)

MSDP mesh group configuration for Device B

The following set of commands configure the MSDP peers of Device B. All Device B peers (1.1.1.1,

1.1.3.1, and 1.1.4.1) are in the MSDP mesh group 1234. Multicast is enabled on Device B

interfaces. PIM and BGP are also enabled.

Brocade(config)# router pim

Brocade(config)# router msdp

Brocade(config-msdp-router)# msdp-peer 1.1.3.1 connect-source loopback 1

Brocade(config-msdp-router)# msdp-peer 1.1.1.1 connect-source loopback 1

Brocade(config-msdp-router)# msdp-peer 1.1.4.1 connect-source loopback 1

Brocade(config-msdp-router)# mesh-group 1234 1.1.1.1

Brocade(config-msdp-router)# mesh-group 1234 1.1.3.1

Brocade(config-msdp-router)# mesh-group 1234 1.1.4.1

Brocade(config-msdp-router)# exit

Brocade(config)# interface loopback 1

Brocade(config-lbif-1)# ip address 1.1.2.1 255.255.255.0

Brocade(config-lbif-1)# ip pim-sparse

Brocade(config-lbif-1)# exit

Brocade(config)# interface ethernet 1/1

Brocade(config-if-1/1)# ip address 12.12.12.2 255.255.255.0

Brocade(config-if-1/1)# ip pim-sparse

Brocade(config-if-1/1)# exit

Brocade(config)# interface ethernet 1/12

Brocade(config-if-1/12)# ip address 165.165.165.1 255.255.255.0

Brocade(config-if-1/12)# ip pim-sparse

Brocade(config-if-1/12)# exit

Brocade(config)# interface ethernet 1/24

Brocade(config-if-1/24)# ip address 168.72.2.2 255.255.255.0

Brocade(config-if-1/24)# exit

Brocade(config)# interface ethernet 1/25

Brocade(config-if-1/25)# ip address 24.24.24.2 255.255.255.0

Brocade(config-if-1/25)# ip pim-sparse

Brocade(config-if-1/24)# exit

Brocade(config)# interface ethernet 8/1

Brocade(config-if-8/1)# ip address 32.32.32.2 255.255.255.0

Brocade(config-if-8/1)# ip pim-sparse

Brocade(config-if-1/24)# exit

Brocade(config)# router pim

Brocade(config-router-pim)# bsr-candidate loopback 1 2 32

Brocade(config-router-pim)# rp-candidate loopback 1

Brocade(config-router-pim)# exit

Brocade(config)# router bgp

Brocade(config-router-bgp)# local-as 222

Brocade(config-router-bgp)# neighbor 32.32.32.3 remote-as 333

Brocade(config-router-bgp)# neighbor 32.32.32.3 next-hop-self

Brocade(config-router-bgp)# neighbor 24.24.24.4 remote-as 444

Brocade(config-router-bgp)# neighbor 24.24.24.4 next-hop-self

Brocade(config-router-bgp)# neighbor 12.12.12.1 remote-as 111