Configuration Guide User guide

1604 FastIron Configuration Guide
53-1002494-02
IGMP V3
Displaying IGMP traffic status
To display the traffic status on each virtual routing interface, enter the show ip igmp traffic
command.
NOTE
This report is available on Layer 3 switches.
Syntax: show ip igmp traffic
The report shows the following information.
Clearing IGMP statistics
To clear statistics for IGMP traffic, enter the clear igmp traffic command.
Brocade#clear igmp traffic
Syntax: clear igmp traffic
This command clears all the multicast traffic information on all interfaces on the device.
TABLE 272 Output of show ip igmp traffic
Field Description
QryV2 Number of general IGMP V2 query received or sent by the virtual routing interface.
QryV3 Number of general IGMP V3 query received or sent by the virtual routing interface.
G-Qry Number of group specific query received or sent by the virtual routing interface.
GSQry Number of source specific query received or sent by the virtual routing interface.
MbrV2 The IGMP V2 membership report.
MbrV3 The IGMP V3 membership report.
Leave Number of IGMP V2 “leave” messages on the interface. (See ToEx for IGMP V3.)
IsIN Number of source addresses that were included in the traffic.
IsEX Number of source addresses that were excluded in the traffic.
ToIN Number of times the interface mode changed from exclude to include.
ToEX Number of times the interface mode changed from include to exclude.
ALLOW Number of times that additional source addresses were allowed or denied on the interface.
BLK Number of times that sources were removed from an interface.
Brocade#show ip igmp traffic
Recv QryV2 QryV3 G-Qry GSQry MbrV2 MbrV3 Leave IsIN IsEX ToIN ToEX ALLOW BLK
v5 29 0 0 0 0 0 0 0 0 0 0 0 0
v18 15 0 0 0 0 30 0 60 0 0 0 0 0
v110 0 0 0 0 0 97 0 142 37 2 2 3 2
Send QryV1 QryV2 QryV3 G-Qry GSQry
v5 0 2 0 0 0
v18 0 0 30 30 0
v110 0 0 30 44 11