Configuration Guide User guide

FastIron Configuration Guide 1695
53-1002494-02
Displaying VRRP and VRRP-E information
To display utilization statistics for a specific number of seconds, enter a command such as the
following. In the following output example, IPv6 protocols are also displayed for a specific number
of seconds.
When you specify how many seconds of statistics you want to display, the software selects the
sample that most closely matches the number of seconds you specified. In this example, statistics
are requested for the previous two seconds. The closest sample available is for the previous 1
second plus 80 milliseconds.
Syntax: show process cpu [<num>]
The <num> variable specifies the number of seconds and can be a value from 1 through 900. If
you use this variable, the command lists the usage statistics only for the specified number of
seconds. If you do not use this variable, the command lists the usage statistics for the previous
one-second, one-minute, five-minute, and fifteen-minute intervals.
Brocade#show process cpu
The system has only been up for 6 seconds.
Process Name 5Sec(%) 1Min(%) 5Min(%) 15Min(%) Runtime(ms)
ARP 0.01 0.00 0.00 0.00 0
BGP 0.00 0.00 0.00 0.00 0
GVRP 0.00 0.00 0.00 0.00 0
ICMP 0.01 0.00 0.00 0.00 1
IP 0.00 0.00 0.00 0.00 0
OSPF 0.00 0.00 0.00 0.00 0
RIP 0.00 0.00 0.00 0.00 0
STP 0.00 0.00 0.00 0.00 0
VRRP 0.00 0.00 0.00 0.00 0
Brocade#show process cpu 2
Statistics for last 1 sec and 999 ms
Process Name Sec(%) Time(ms)
ARP 0.01 0
BGP 0.00 0
DOT1X 0.00 0
GVRP 0.00 0
ICMP 0.01 0
IP 0.04 0
OSPF 0.07 1
RIP 0.00 0
STP 0.97 19
VRRP 0.53 10
Statistics for last 1 sec and 999 ms
Process Name Sec(%) Time(ms)
IPv6 0.09 1
ICMP6 0.05 1
ND6 0.00 0
RIPng 0.00 0
OSPFv3 0.00 0
IPV6_RX 0.04 0