Configuration Guide User guide

FastIron Configuration Guide 1701
53-1002494-02
Configuration examples
Brocade Switch2(config-if-5/1-vrid-1)#exit
Brocade Switch2(config)#interface ethernet 5/1
Brocade Switch2(config-if-5/1)#ip vrrp-extended vrid 2
Brocade Switch2(config-if-5/1-vrid-1)#backup priority 110 track-priority 20
Brocade Switch2(config-if-5/1-vrid-1)#track-port ethernet 2/4
Brocade Switch2(config-if-5/1-vrid-1)#ip-address 192.53.5.253
Brocade Switch2(config-if-5/1-vrid-1)#activate
VRRP Switch 2 for this interface is activating
The backup command specifies that this router is a VRRP-E Backup for virtual router VRID1. The IP
address entered with the ip-address command is the same IP address as the one entered when
configuring Switch 1. In this case, the IP address cannot also exist on Switch 2, but the interface
on which you are configuring the VRID Backup must have an IP address in the same subnet. By
entering the same IP address as the one associated with this VRID on the Owner, you are
configuring the Backup to back up the address, but you are not duplicating the address.
NOTE
When you configure a Backup router, the router interface on which you are configuring the VRID
must have a real IP address that is in the same subnet as the address associated with the VRID by
the Owner. However, the address cannot be the same.
The priority parameter establishes the router VRRP-E priority in relation to the other VRRP-E routers
in this virtual router. The track-priority parameter specifies the new VRRP-E priority that the router
receives for this VRID if the interface goes down. Refer to “Track ports and track priority” on
page 1654.
The activate command activates the VRID configuration on this interface. The interface does not
provide backup service for the virtual IP address until you activate the VRRP-E configuration.
Alternatively, you can use the enable command. The activate and enable commands do the same
thing.
Syntax: router vrrp-extended
Syntax: ip vrrp-extended vrid <vrid>
Syntax: backup [priority <value>] [track-priority <value>]
Syntax: track-port ethernet [<slotnum>/]<portnum> | ve <num>
Syntax: ip-address <ip-addr>
Syntax: activate