Manualshelf

Configuration Guide User guide

ManualsBrandsBrocade ManualsComputer AccessoriesFastIron
1881188218831884188518861887188818891890
1826 FastIron Configuration Guide
53-1002494-02
Displaying 802.1X information
The show run command also indicates the VLAN to which the port has been dynamically assigned.
The output can differ depending on whether GARP VLAN Registration Protocol (GVRP) is enabled on
the device:
• Without GVRP – When you enter the show run command, the output indicates that the port is a
member of the VLAN to which it was dynamically assigned through 802.1X. If you then enter
the write memory command, the VLAN to which the port is currently assigned becomes the
port default VLAN in the device configuration.
• With GVRP – When you enter the show run command, if the VLAN name supplied by the
RADIUS server corresponds to a VLAN learned through GVRP, then the output indicates that
the port is a member of the VLAN to which it was originally assigned (not the VLAN to which it
was dynamically assigned).
If the VLAN name supplied by the RADIUS server corresponds to a statically configured VLAN,
the output indicates that the port is a member of the VLAN to which it was dynamically
assigned through 802.1X. If you then enter the write memory command, the VLAN to which the
port is currently assigned becomes the port default VLAN in the device configuration.
Displaying information about dynamically applied
MAC address filters and IP ACLs
You can display information about currently active user-defined and dynamically applied MAC
address filters and IP ACLs.
Displaying user-defined MAC address filters and IP ACLs
To display the user-defined MAC address filters active on the device, enter the following command.
Brocade#show dot1x mac-address filter
Port 1/3 (User defined MAC Address Filter) :
mac filter 1 permit any any
Syntax: show dot1x mac-address-filter
To display the user-defined IP ACLs active on the device, enter the show dot1x ip-ACL command.
Syntax: show dot1x ip-ACL
Brocade#show dot1x ip-ACL
Port 1/3 (User defined IP ACLs):
Extended IP access list Port_1/3_E_IN
permit udp any any
Extended IP access list Port_1/3_E_OUT
permit udp any any