Configuration Guide User guide

1834 FastIron Configuration Guide
53-1002494-02
Sample 802.1X configurations
Brocade(config)#interface e 3
Brocade(config-if-e1000-3)#dot1x port-control auto
Brocade(config-if-e1000-3)#exit
Hub configuration
Figure 194 illustrates a configuration where three 802.1X-enabled Clients are connected to a hub,
which is connected to a port on the Brocade device. The configuration is similar to that in
Figure 193, except that 802.1X port security is enabled on only one port, and the multiple-hosts
command is used to allow multiple Clients on the port.
FIGURE 194 Sample 802.1X configuration using a hub
Sample 802.1x configuration using a hub
The following commands configure the Brocade device in Figure 194
Brocade(config)#aaa authentication dot1x default radius
Brocade(config)#radius-server host 192.168.9.22 auth-port 1812 acct-port 1813
default key mirabeau dot1x
Brocade(config)#dot1x-enable e 1
Brocade(config-dot1x)#re-authentication
Brocade(config-dot1x)#timeout re-authperiod 2000
Brocade(config-dot1x)#timeout quiet-period 30
Brocade(config-dot1x)#timeout tx-period 60
Brocade(config-dot1x)#maxreq 6
Brocade(config-dot1x)#exit
Brocade(config)#interface e 1
Brocade(config-if-e1000-1)#dot1x port-control auto
Brocade(config-if-e1000-1)#exit
RADIUS Server
(Authentication Server)
FastIron Switch
(Authenticator)
Clients/Supplicants running 802.1X-compliant client software
e2/1
192.168.9.22
Hub