Configuration Guide User guide

FastIron Configuration Guide 2007
53-1002494-02
Syslog messages
Notification DOT1X issues software but not physical port
down indication of Port <portnum> to other
software applications
The device has indicated that the specified
is no longer authorized, but the actual port
may still be active.
Notification DOT1X issues software but not physical port
up indication of Port <portnum> to other
software applications
The device has indicated that the specified
port has been authenticated, but the actual
port may not be active.
Notification DOT1X: Port <port_id> Mac <mac_address>
-user <user_id> - RADIUS timeout for
authentication
The RADIUS session has timed out for this
802.1x port.
Notification ISIS L1 ADJACENCY DOWN <system-id> on
circuit <circuit-id>
The Layer 3 switch adjacency with this
Level-1 IS has gone down.
The <system-id> is the system ID of the IS.
The <circuit-id> is the ID of the circuit over
which the adjacency was established.
Notification ISIS L1 ADJACENCY UP <system-id> on
circuit <circuit-id>
The Layer 3 switch adjacency with this
Level-1 IS has come up.
The <system-id> is the system ID of the IS.
The <circuit-id> is the ID of the circuit over
which the adjacency was established.
Notification ISIS L2 ADJACENCY DOWN <system-id> on
circuit <circuit-id>
The Layer 3 switch adjacency with this
Level-2 IS has gone down.
The <system-id> is the system ID of the IS.
The <circuit-id> is the ID of the circuit over
which the adjacency was established.
Notification ISIS L2 ADJACENCY UP <system-id> on
circuit <circuit-id>
The Layer 3 switch adjacency with this
Level-2 IS has come up.
The <system-id> is the system ID of the IS.
The <circuit-id> is the ID of the circuit over
which the adjacency was established.
Notification Local ICMP exceeds <burst-max> burst
packets, stopping for <lockup> seconds!!
The number of ICMP packets exceeds the
<burst-max> threshold set by the ip icmp
burst command. The Brocade device may
be the victim of a Denial of Service (DoS)
attack.
All ICMP packets will be dropped for the
number of seconds specified by the
<lockup> value. When the lockup period
expires, the packet counter is reset and
measurement is restarted.
Notification Local TCP exceeds <burst-max> burst
packets, stopping for <lockup> seconds!!
The number of TCP SYN packets exceeds
the <burst-max> threshold set by the ip tcp
burst command. The Brocade device may
be the victim of a TCP SYN DoS attack.
All TCP SYN packets will be dropped for the
number of seconds specified by the
<lockup> value. When the lockup period
expires, the packet counter is reset and
measurement is restarted.
TABLE 1 Brocade Syslog messages (Continued)
Message level Message Explanation