Configuration Guide User guide

FastIron Configuration Guide 227

53-1002494-02

Syslog messages and trap information

Table 36 lists the syslog messages and traps that are supported for software-based licensing.

Viewing information about software licenses

This section describes the show commands associated with software-based licensing. These

commands are issued on the Brocade device, at any level of the CLI.

NOTE

You can also view information about software licenses from the Brocade software portal. Refer to

“Viewing software license information from the Brocade software portal” on page 224.

Viewing the License ID

Brocade devices that ship during and after the release of software-based licensing have the

License ID (LID) imprinted on the label affixed to the device. You also can use the show version CLI

command to view the LID on these devices, and on devices that shipped before the release of

software-based licensing.

Use the show version command to display the serial number, software and hardware license

package name, and LID of all units in the device. The following example is sample output from an

FCX unit with the package FCX_ADV_ROUTER_SOFT_PACKAGE installed on units 1, 3, and 5.

Brocade#show version

UNIT 5: compiled on Jun 24 2011 at 14:20:38 labeled as FCXR07203a