Configuration Guide User guide

FastIron Configuration Guide 253
53-1002494-02
Connecting ICX 6450 and ICX 6430 devices in a stack
Brocade# stack secure-setup
Brocade# Discovering the stack topology...
Verifying password for the password protected units...
Found UPSTREAM units
Hop(s) Type Mac Address
1 2 FCX648 001b.ed5e.c480
2 3 FCX648 00e0.5205.0000
Enter password for FCX648 located at 2 hop(s): ****
Enter the number of the desired UPSTREAM units (1-2)[1]: 2
Selected Topology:
Active Id Type Mac Address
1 FCX624 00e0.5201.4000
Selected UPSTREAM units
Hop(s) Id Type Mac Address
1 2 FCX648 001b.ed5e.c480
2 3 FCX648 00e0.5205.0000
Do you accept the unit id's (y/n)?: y
7. When the Active Controller has finished the authentication process, you will see output that
shows the suggested assigned stack IDs for each member. You can accept these
recommendations, or you can manually configure stack IDs. Enter the show stack command to
verify that all units are in the ready state.
Brocade# show stack
alone: standalone, D: dynamic config, S: static config
ID Type Role Mac Address Pri State Comment
1 S FCX624 active 00e0.5201.4000 128 local Ready
2 S FCX648 standby 001b.ed5e.c480 0 remote Ready
3 S FCX648 member 00e0.5205.0000 0 remote Ready
active standby
+---+ +---+ +---+
-2/1| 1 |3/1--2/1| 2 |3/1--2/2| 3 |2/1-
| +---+ +---+ +---+ |
| |
|-------------------------------------|
Current stack management MAC is 00e0.5201.4000
Brocade#
For ICX devices, it displays the port up state of all ports of the trunk, for example:
ICX6610-24P POE Router#show stack stack-port
active standby
+---+ +---+ +---+
=2/1| 1 |2/6==2/6| 5 |2/1==2/1| 4 |2/6=
| +---+ +---+ +---+ |
| |
|-------------------------------------|
U# Stack-port1 Stack-port2
1 up (1/2/1-1/2/5) up (1/2/6-1/2/10)