Configuration Guide User guide

ManualsBrandsBrocade ManualsComputer AccessoriesFastIron

311

312

313

314

315

316

317

318

319

320

260 FastIron Configuration Guide

53-1002494-02

FCX IronStack configuration

Link Error Dampening is Disabled

STP configured to ON, priority is level0, mac-learning is enabled

Flow Control is enabled

mirror disabled, monitor disabled

Not member of any active trunks

Not member of any configured trunks

No port name

IP MTU 1500 bytes, encapsulation ethernet

300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization

300 second output rate: 0 bits/sec, 0 packets/sec, 0.00% utilization

0 packets input, 0 bytes, 0 no buffer

Received 0 broadcasts, 0 multicasts, 0 unicasts

0 input errors, 0 CRC, 0 frame, 0 ignored

0 runts, 0 giants

0 packets output, 0 bytes, 0 underruns

Transmitted 0 broadcasts, 0 multicasts, 0 unicasts

0 output errors, 0 collisions

Relay Agent Information option: Disabled

Changing FCX-S and FCXS-F CX4 ports from 10 Gbps to 16 Gbps

To change the CX4 ports from 10 Gbps back to 16 Gbps, enter the no speed-duplex 10g command

at the interface level of the CLI, as shown in this example.

Brocade(config-if-e10000-cx4-1/2/1)# no speed-duplex 10g

Brocade(config-if-e10000-cx4-1/2/1)# show interface br | in Up

1/1/4 Up Forward Full 1G None No 1 0 001b.f288.0003

1/2/1 Up Forward Full 16G None No 1 0 001b.f288.0019

1/3/1 Up Forward Full 10G None No N/A 0 001b.f288.001b

3/3/1 Up Forward Full 10G None No N/A 0 0024.3814.9df3

mgmt1 Up None Full 1G None No 1 0 001b.f288.0018

Brocade(config-if-e10000-cx4-1/2/1)# show interface e 1/2/1

16GigabitEthernet1/2/1 is up, line protocol is up

Hardware is 16GigabitEthernet, address is 001b.f288.0019 (bia 001b.f288.0019)

Interface type is 16Gig CX4

Configured speed 16Gbit, actual 16Gbit, configured duplex fdx, actual fdx

Member of L2 VLAN ID 1, port is untagged, port state is FORWARDING

BPDU guard is Disabled, ROOT protect is Disabled