Configuration Guide User guide

FastIron Configuration Guide 263
53-1002494-02
FCX IronStack configuration
Using secure-setup to build an FCX IronStack
You can use the secure-setup utility to build an FCX IronStack by performing the following step.
Enter stack enable and stack secure-setup commands when you have designated the desired
stacking ports and connected your FCX units together, on stack unit 1, as shown in the following
output.
Brocade# stack enable
Brocade# stack secure-setup
Brocade# Discovering the stack topology...
Available UPSTREAM units
Hop(s) Id Type Mac Address
1 new FCX648POE 0012.f2d6.0511
2 new FCX624 0200.9999.0000
Enter the number of the desired UPSTREAM units (0-2)[0]: 2
Selected Topology:
Active Id Type Mac Address
1 FCX624POE 001b.f2e5.0100
Selected UPSTREAM units
Hop(s) Id Type Mac Address
1 2 FCX648POE 0012.f2d6.0511
2 3 FCX624 0200.9999.0000
Do you accept the unit ids (y/n)?: y
Brocade# Election, was alone --> active, assigned-ID=1, total 3 units, my
priority=128
Election, was active, no role change, assigned-ID=1, total 3 units, my
priority=128
reset unit 2: diff bootup id=1
reset unit 3: diff bootup id=1
Election, was alone --> active, assigned-ID=1, total 3 units, my priority=128
Detect stack member 2 POE capable
Detect stack unit 2 has different startup config flash, will synchronize it
Detect stack unit 3 has different startup config flash, will synchronize it
Done hot swap: Set stack unit 3 to Ready
Done hot swap: Set stack unit 2 to Ready
Synchronize startup config to stack unit 2
Flash Memory Write (8192 bytes per dot).Synchronize startup config to stack
unit 3
Flash Memory Write (8192 bytes per dot).POE: Stack unit 2 Power supply 1 with 4
10000 mwatts capacity is up
Stack unit 2 Power supply 2 is down
Stack unit 3 Power supply 1 is up
Stack unit 3 Power supply 2 is down
Config changed due to add/del units. Do write mem if you want to keep it
Election, was active, no role change, assigned-ID=1, total 3 units, my
priority=128
Brocade#
Config changed due to add/del units. Do write mem if you want to keep it
Brocade# PoE Info: PoE module 1 of Unit 2 on ports 2/1/1 to 2/1/48 detected.
Initializing....
PoE Info: PoE module 1 of Unit 2 initialization is done.