Configuration Guide User guide

FastIron Configuration Guide 279
53-1002494-02
Brocade IronStack management
CLI command syntax for stack units
CLI syntax that refers to stack units must contain all of the following parameters:
<stack-unit>/<slotnum>/<portnum>
• <stack-unit> - If the device is operating as a standalone, the stack-unit will be 1. Stack IDs can
be any number from 1 through 8.
• <slotnum> - Refers to a specific group of ports on each device.
• <portnum> - A valid port number.
IronStack CLI commands
CLI commands specific to stacking are listed in Table 41, with a link to the description for each
command. For more information about CLI commands and syntax conventions, refer to 1,
“Management Applications”.
TABLE 41 Stacking CLI commands
Command Description location
copy flash flash “Copying the flash image to a stack unit from the Active Controller” on
page 283
clear stack ipc “Troubleshooting an unsuccessful stack build” on page 315
cx4-10g “Changing FCX-S and FCXS-F CX4 ports from 16 Gbps to 10 Gbps” on page 259
kill console “Configuring TACACS/TACACS+ for devices in a Brocade IronStack” on page 140
priority “Changing the priority of a stack unit” on page 278
rconsole “Logging in through the console port” on page 273
reload stack unit “Reloading a stack unit” on page 283
show chassis “Displaying IronStack chassis information” on page 291
show flash “Displaying IronStack flash information” on page 289
show memory “Displaying IronStack memory information” on page 290
show module “Displaying stack module information” on page 292
show running-config “Displaying running configuration information” on page 305
show stack “Displaying stack information” on page 293
show stack detail “Displaying stack information” on page 293
show stack flash “Displaying stack flash information” on page 296
show stack ipc “Troubleshooting an unsuccessful stack build” on page 315
show stack neighbors “Displaying stack neighbors information” on page 303
show stack resource “Displaying stack information” on page 293
show stack rel-ipc stats “Displaying stack rel-IPC statistics” on page 297
show stack rel-ipc stats unit # “Displaying stack rel-IPC statistics for a specific stack unit” on page 301
show stack stack-port “Displaying stack port information” on page 304
show statistics stack-port “Displaying stacking port statistics” on page 309
show interfaces stack-ports “Displaying stacking port interface information” on page 308