Configuration Guide User guide

296 FastIron Configuration Guide
53-1002494-02
Brocade IronStack management
NOTE
The Active Controller removes the dynamic configuration of a unit when the unit leaves. However, if
there is a static trunk configuration associated with the unit, the Active Controller cannot remove the
dynamic configuration. In this case, you must remove the static trunk and use the no stack unit x to
manually remove the configuration.
Table 48 describes the output from the show stack detail command (in addition to the show stack
command fields shown in the previous table).
Displaying stack flash information
Use the show stack flash command to display information about flash memory for stack members,
as shown in this example output from a Brocade ICX 6610 switch.
Brocade# show stack flash
There is no startup-config.old
Stack flash that was read in bootup:
ICX6610-48P, ID =4, role= active, pri=200, config=1, jumbo=X PPVLAN=X S2M=0 FIPS=X
stack p: [0]=4/2/1 [1]=4/2/6 default p: 4/2/1(5) 4/2/6(5), , , hash-chain=X
vlan#=X ve#=X stp#=X
active-chg=0
Current written stack flash:
ICX6610-48P, ID =4, role= active, pri=200, config=1, jumbo=X PPVLAN=X S2M=0 FIPS=X
stack p: [0]=4/2/1 [1]=4/2/6 default p: 4/2/1(5) 4/2/6(5), , , hash-chain=X
vlan#=X ve#=X stp#=X
active-chg=0
State The operational state of this unit.
Comments Additional information about this unit (optional).
TABLE 48 Field descriptions for the show stack detail command
Field Description
Stack Port Status Indicates stacking port status for each stack unit.
Neighbors Identifies stack neighbors (by unit ID) for each stack unit.
ID The stack identification number for this unit.
Stack-port 1 Indicates the port state (up or down) and identifies the port by number
(stack-ID/slot/port).
Stack-port 2 Indicates the port state (up or down) and identifies the port by number
(stack-ID/slot/port).
TABLE 47 Field descriptions for the show stack command (Continued)
Field Description