Configuration Guide User guide

306 FastIron Configuration Guide
53-1002494-02
Brocade IronStack management
module 3 icx6610-8-port-10g-dual-mode-module
priority 128
stack-trunk 1/2/1 to 1/2/2
stack-trunk 1/2/6 to 1/2/7
stack-port 1/2/1 1/2/6
stack unit 4
module 1 icx6610-48p-poe-port-management-module
module 2 icx6610-qsfp-10-port-160g-module
module 3 icx6610-8-port-10g-dual-mode-module
priority 100
stack-trunk 4/2/1 to 4/2/2
stack-trunk 4/2/6 to 4/2/7
stack-port 4/2/1 4/2/6
stack unit 5
module 1 icx6610-48-port-management-module
module 2 icx6610-qsfp-10-port-160g-module
module 3 icx6610-8-port-10g-dual-mode-module
priority 128
stack-trunk 5/2/1 to 5/2/2
stack-trunk 5/2/6 to 5/2/7
stack-port 5/2/1 5/2/6
stack enable
Syntax: show running-config
Table 52 describes the output from the show running-config command.
Displaying configured stacking ports
The stacking ports may display in the output from the show running-config command in three
different ways.
1. When stacking is enabled, the output shows both stacking ports.
stack unit 1
module 1 fcx-24-port-management-module
module 2 fcx-cx4-2-port-10g-module
module 3 fcx-xfp-1-port-10g-module
stack-port 1/2/1 1/3/1
2. When stacking is not enabled, neither stacking port is displayed.
stack unit 1
module 1 fcx-24-port-management-module
module 2 fcx-cx4-2-port-10g-module
module 3 fcx-xfp-1-port-10g-module
TABLE 52 Field descriptions for the show running-config command
Field Description
stack unit <#> The stack identification number for this unit.
module <#> Identifies the configuration for modules on this unit.
priority Indicates that a priority has been assigned to this stack unit
stack-trunk Indicates the trunk configuration
1
1. For ICX devices, software version 7.3 always shows two primary ports of two stacking trunks. The user cannot
define just one stacking port as for FCX devices.