Configuration Guide User guide

318 FastIron Configuration Guide
53-1002494-02
Stack mismatches
BOOT INFO: load monitor from primary, size=103408
BOOT INFO: load image from primary..........
BOOT INFO: bootparam at 000543e8, mp_flash_size=002ee6c5
BOOT INFO: code decompression completed
BOOT INFO: branch to 00400100
Starting Main Task.......
*****************************************************************************
ERR: This software needs License PROM to be installed in the system
*****************************************************************************
System Reset!
If your memory DIMM is not installed correctly, you will see output similar to the following.
FCX Mem size: 0x8000000
Flash Config...
FCX Boot Code Version 05.0.00
Enter ‘b’ to stop at boot.....
BOOT INFO: load monitor from primary, size = 103380
BOOT INFO: debug enabled!!
BOOT INFO: load image from primary...
BOOT INFO: bootparam at 00054338 mp_flash_size = 002f1aeb
BOOT INFO: code decompression completed
BOOT INFO: branch to 00400100
Starting Main Task ...
*****************************************************************************
ERR: This software requires 256M memory to be installed in the system.
*****************************************************************************
System Reset!
Check your upgraded hardware for the following situations:
• EEPROM is installed incorrectly in the socket. Make sure Pin 1 on the EEPROM matches the
Pin 1 hole in the socket.
• Make sure your memory DIMM is securely installed in the memory DIMM socket. Refer to the
hardware installation guide or the instructions that came with your upgrade kit for more
information.
Troubleshooting image copy issues
The copy tftp flash command copies the image to all stack units including the Active Controller. The
copy flash flash command copies the image from the primary or secondary flash on the Active
Controller to the primary or secondary flash image of a stack member, respectively. If you are
unable to copy an image to one or more stack units, check the following:
• Make sure the unit is actually part of the stack. Use the show stack command.
• If a unit joins a stack after the image copy command was issued, you will need to copy the
image to this unit separately.
Stack mismatches
When a stack mismatch occurs, the Active Controller can put any stack member into a
non-operational state, which disables all of the ports except the stacking ports. Stack mismatches
can occur for a variety of reasons, which are discussed in this section.