Configuration Guide User guide

380 FastIron Configuration Guide
53-1002494-02
IPv6 over IPv4 tunnels
Displaying interface level IPv6 settings
To display Interface level IPv6 settings for tunnel interface 1, enter the following command at any
level of the CLI.
The display command above reflects the following configuration.
This display shows the following information.
Port name The port name configured for the tunnel interface.
MTU The setting of the IPv6 maximum transmission unit (MTU).
TABLE 63 IPv6 tunnel interface information (Continued)
Field Description
Brocade#show ipv6 inter tunnel 1
Interface Tunnel 1 is up, line protocol is up
IPv6 is enabled, link-local address is fe80::3:4:2 [Preferred]
Global unicast address(es):
1001::1 [Preferred], subnet is 1001::/64
1011::1 [Preferred], subnet is 1011::/64
Joined group address(es):
ff02::1:ff04:2
ff02::5
ff02::1:ff00:1
ff02::2
ff02::1
MTU is 1480 bytes
ICMP redirects are enabled
No Inbound Access List Set
No Outbound Access List Set
OSPF enabled
Brocade#show running-config interface tunnel 1
!
interface tunnel 1
port-name ManualTunnel1
tunnel mode ipv6ip
tunnel source loopback 1
tunnel destination 2.1.1.1
ipv6 address 1011::1/64
ipv6 address 1001::1/64
ipv6 ospf area 0