Configuration Guide User guide

398 FastIron Configuration Guide
53-1002494-02
Displaying global IPv6 information
Displaying IPv6 interface information
To display IPv6 interface information, enter the following command at any CLI level.
Syntax: show ipv6 interface [<interface> [<port-number> |<number>]]
The <interface> parameter displays detailed information for a specified interface. For the interface,
you can specify the Ethernet, loopback, tunnel, or VE keywords. If you specify an Ethernet interface,
also specify the port number associated with the interface. If you specify a loopback, tunnel, or VE
interface, also specify the number associated with the interface.
This display shows the following information.
To display detailed information for a specific interface, enter a command such as the following at
any CLI level.
TABLE 67 General IPv6 interface information fields
Field Description
Routing protocols A one-letter code that represents a routing protocol that can be enabled
on an interface.
Interface The interface type, and the port number or number of the interface.
Status The status of the interface. The entry in the Status field will be either
“up/up” or “down/down”.
Routing The routing protocols enabled on the interface.
Global Unicast Address The global unicast address of the interface.
Brocade#show ipv6 interface
Routing Protocols : R - RIP O - OSPF
Interface Status Routing Global Unicast Address
Ethernet 3/3 down/down R
Ethernet 3/5 down/down
Ethernet 3/17 up/up 2017::c017:101/64
Ethernet 3/19 up/up 2019::c019:101/64
VE 4 down/down
VE 14 up/up 2024::c060:101/64
Loopback 1 up/up ::1/128
Loopback 2 up/up 2005::303:303/128
Loopback 3 up/up