Configuration Guide User guide
FastIron Configuration Guide 419
53-1002494-02
IPv6 management commands
IPv6 traceroute
The traceroute command allows you to trace a path from the Brocade device to an IPv6 host.
The CLI displays trace route information for each hop as soon as the information is received.
Traceroute requests display all responses to a minimum TTL of 1 second and a maximum TTL of 30
seconds. In addition, if there are multiple equal-cost routes to the destination, the Brocade device
displays up to three responses.
For example, to trace the path from the Brocade device to a host with an IPv6 address of
3301:23dd:349e:a384::34, enter the traceroute ipv6 command.
Brocade#traceroute ipv6 3301:23dd:349e:a384::34
Syntax: traceroute ipv6 <ipv6-address>
The <ipv6-address> parameter specifies the address of a host. You must specify this address in
hexadecimal using 16-bit values between colons as documented in RFC 2373.
IPv6 management commands
The following management CLI commands are available in FastIron devices that support IPv6:
• show ipv6 traffic
• clear ipv6 traffic
• show ipv6 TCP
• show ipv6 access-list
• show ipv6 neighbor
• clear ipv6 neighbor