Configuration Guide User guide

488 FastIron Configuration Guide
53-1002494-02
LLDP-MED attributes advertised by the Brocade device
Brocade(config)#no lldp advertise med-power-via-mdi ports e 2/4 to 2/12
The LLDP-MED power-via-MDI advertisement will appear similar to the following on the remote
device, and in the CLI display output on the Brocade device (show lldp local-info).
Syntax: [no] lldp advertise med-power-via-mdi ports ethernet <port-list> | all
For port-list , specify the ports in one of the following formats:
• FWS, FCX, and ICX stackable switches – stack-unit/slotnum/portnum
• FSX 800 and FSX 1600 chassis devices – slotnum/portnum
• FESX compact switches – portnum
You can list all of the ports individually, use the keyword to to specify ranges of ports, or a
combination of both. To apply the configuration to all ports on the device, use the keyword all
instead of listing the ports individually. Note that using the keyword all may cause undesirable
effects on some ports. For example, if you configure all ports to advertise their VLAN name, and the
configuration includes ports that are not members of any VLAN, the system will warn of the
misconfigurations on non-member VLAN ports. The configuration will be applied to all ports,
however, the ports that are not members of any VLAN will not send VLAN name advertisements.
Displaying LLDP statistics and configuration settings
You can use the following CLI show commands to display information about LLDP settings and
statistics:
• show lldp – Displays a summary of the LLDP configuration settings.
• show lldp statistics – Displays LLDP global and per-port statistics.
• show lldp neighbors – Displays a list of the current LLDP neighbors.
• show lldp neighbors detail – Displays the details of the latest advertisements received from
LLDP neighbors.
• show lldp local-info – Displays the details of the LLDP advertisements that will be transmitted
on each port.
This above show commands are described in this section.
LLDP configuration summary
To display a summary of the LLDP configuration settings on the device, enter the show lldp
command at any level of the CLI.
The following shows an example report.
+ MED Extended Power via MDI
Power Type : PSE device
Power Source : Unknown Power Source
Power Priority : Low (3)
Power Value : 6.5 watts (PSE equivalent: 7005 mWatts)