Configuration Guide User guide

652 FastIron Configuration Guide
53-1002494-02
VSRP
Displaying VRID information
To display VSRP information, enter the following command.
Syntax: show vsrp [vrid <num> | vlan <vlan-id>]
This display shows the following information when you use the vrid <num> or vlan <vlan-id>
parameter. For information about the display when you use the aware parameter, refer to
“Displaying the active interfaces for a VRID” on page 654.
TABLE 119 CLI display of VSRP VRID or VLAN information
Field Description
Total number of VSRP
routers defined
The total number of VRIDs configured on this device.
VLAN The VLAN on which VSRP is configured.
auth-type The authentication type in effect on the ports in the VSRP VLAN.
VRID parameters
VRID The VRID for which the following information is displayed.
state This device VSRP state for the VRID. The state can be one of the following:
• initialize – The VRID is not enabled (activated). If the state remains “initialize”
after you activate the VRID, make sure that the VRID is also configured on the
other routers and that the routers can communicate with each other.
NOTE: If the state is “initialize” and the mode is incomplete, make sure you have
specified the IP address for the VRID.
• standby – This device is a Backup for the VRID.
• master – This device is the Master for the VRID.
Administrative-status The administrative status of the VRID. The administrative status can be one of the
following:
• disabled – The VRID is configured on the interface but VSRP or VRRP-E has not
been activated on the interface.
• enabled – VSRP has been activated on the interface.
Brocade#show vsrp vrid 1
Total number of VSRP routers defined: 2
VLAN 200
auth-type no authentication
VRID 1
State Administrative-status Advertise-backup Preempt-mode save-current
standby enabled disabled true false
Parameter Configured Current Unit
priority 100 80 (100-0)*(4.0/5.0)
hello-interval 1 1 sec/1
dead-interval 3 3 sec/1
hold-interval 3 3 sec/1
initial-ttl 2 2 hops
next hello sent in 00:00:00.8
Member ports: ethe 1/1 to 1/5
Operational ports: ethe 1/1 to 1/4
Forwarding ports: ethe 1/1 to 1/4