Configuration Guide User guide

22 FastIron Configuration Guide
53-1002494-02
Basic system parameter configuration
SNMP Layer 3 traps
The following traps are generated on devices running Layer 3 software:
• SNMP authentication key
• Power supply failure
• Fan failure
• Cold start
• Link up
• Link down
• Bridge new root
• Bridge topology change
• Locked address violation
• BGP4
• OSPF
• VRRP
• VRRP-E
To stop link down occurrences from being reported, enter the following.
Brocade(config)# no snmp-server enable traps link-down
Syntax: [no] snmp-server enable traps <trap-type>
Displaying virtual routing interface statistics
NOTE
This feature is supported on FastIron X Series devices only.
You can enable SNMP to extract and display virtual routing interface statistics from the ifXTable
(64-bit counters).
The following describes the limitations of this feature:
• The Brocade device counts traffic from all virtual interfaces (VEs). For example, in a
configuration with two VLANs (VLAN 1 and VLAN 20) on port 1, when traffic is sent on VLAN 1,
the counters (VE statistics) increase for both VE 1 and VE 20.
• The counters include all traffic on each virtual interface, even if the virtual interface is
disabled.
• The counters include traffic that is denied by ACLs or MAC address filters.
To enable SNMP to display VE statistics, enter the enable snmp ve-statistics command.
Brocade(config)# enable snmp ve-statistics
Syntax: [no] enable snmp ve-statistics
Use the no form of the command to disable this feature once it is enabled.
Note that the above CLI command enables SNMP to display virtual interface statistics. It does not
enable the CLI or Web Management Interface to display the statistics.