Configuration Guide User guide

FastIron Configuration Guide 747
53-1002494-02
VLAN overview
The following VLAN parameters can be configured with the specified VLAN range.
NOTE
In FSX and FESX platforms, the mac-vlan-permit command is not available in the multi-range vlan
configuration mode.
The VLAN parameters configured for the VLAN range are written in the configuration file of the
individual VLANs. These VLAN parameters can also be removed or modified from the individual
VLANs. In the following example, as the first step, create VLANs 16 17 20 21 22 23 24. Further, as
the second step, add Ethernet port 1/1/1 in all the VLANs. As the third step, enabled 802.1w
spanning tree on all these VLANs.
Brocade(config)#vlan 16 17 20 to 24
Brocade(config-mvlan-16*24)#tag e 1/1/1
Brocade(config-mvlan-16*24)#
Added tagged port(s) ethe 1/1/1 to port-vlan16.
Added tagged port(s) ethe 1/1/1 to port-vlan 17.
Added tagged port(s) ethe 1/1/1 to port-vlan 20.
Added tagged port(s) ethe 1/1/1 to port-vlan 21.
Command Explanation
atalk-proto Set AppleTalk protocol VLAN
clear Clear table/statistics/keys
decnet-proto Set decnet protocol VLAN
end End Configuration level and goto Privileged level
exit Exit current level
ip-proto Set IP protocol VLAN
ipv6-proto Set IPv6 protocol VLAN
ipx-proto Set IPX protocol VLAN
mac-vlan-permit Define port to be used for MAC Based VLan
monitor Monitor Ingress Traffic on this VLAN(Enable VLAN
Mirroring)
multicast IGMP snooping on this VLAN
netbios-proto Set netbios protocol VLAN
no Undo/disable commands
other-proto Set other protocol VLAN
quit Exit to User level
show Show system information
spanning-tree Set spanning tree for this VLAN
static-mac-address Configure static MAC for this VLAN
tagged 802.1Q tagged port
uplink-switch Define uplink ports and enable uplink switching
vsrp Configure VSRP
vsrp-aware Configure VSRP Aware parameters
write Write running configuration to flash or terminal