Configuration Guide User guide

FastIron Configuration Guide 785
53-1002494-02
Configuring protocol VLANs with dynamic ports
NOTE
Use the first untagged command for adding a range of ports. Use the second command for adding
separate ports (not in a range).
Syntax: ip-proto [name <string>]
Syntax: ipx-proto [name <string>]
Syntax: appletalk-cable-vlan <num> [name <string>]
Syntax: dynamic
The procedure is similar for IPX and AppleTalk protocol VLANs. Enter ipx-proto or atalk-proto instead
of ip-proto.
Configuring an IP subnet VLAN with dynamic ports
To configure port-based VLAN 10, then configure an IP subnet VLAN within the port-based VLAN
with dynamic ports, enter commands such as the following.
Brocade(config)# vlan 10 name IP_VLAN by port
Brocade(config-vlan-10)# untagged ethernet 1/1 to 1/6
added untagged port ethe 1/1 to 1/6 to port-vlan 10.
Brocade(config-vlan-10)# ip-subnet 1.1.1.0/24 name Mktg-LAN
Brocade(config-vlan-ip-subnet)# dynamic
Brocade(config)# write memory
These commands create a port-based VLAN on chassis ports 1/1 – 1/6 named “Mktg-LAN”,
configure an IP subnet VLAN within the port-based VLAN, and then add ports from the port-based
VLAN dynamically.
Syntax: vlan <vlan-id> name <string> [by port]
Syntax: untagged ethernet [<slotnum>/]<portnum> to [<slotnum>/]<portnum>
or
Syntax: untagged ethernet [<slotnum>/]<portnum> ethernet [<slotnum>/]<portnum>
NOTE
Use the first untagged command for adding a range of ports. Use the second command for adding
separate ports (not in a range).
Syntax: ip-subnet <ip-addr> <ip-mask> [name <string>]
or
Syntax: ip-subnet <ip-addr>/<mask-bits> [name <string>]
Syntax: dynamic
Configuring an IPX network VLAN with dynamic ports
To configure port-based VLAN 20, then configure an IPX network VLAN within the port-based VLAN
with dynamic ports, enter commands such as the following.