Configuration Guide User guide

806 FastIron Configuration Guide
53-1002494-02
802.1ad tagging configuration
The ethernet <port> to <port> parameter specifies the ports that will use the defined 802.1Q tag.
This parameter operates with the following rules:
If you specify a single port number, the 802.1Q tag applies to all ports within the port region.
For example, if you enter the command tag-type 9100 ethernet 1, the Brocade device
automatically applies the 802.1Q tag to ports 1 – 12 because all of these ports are in the
same port region. You can use the show running-config command to view how the command
has been applied.
If you do not specify a port or range of ports, the 802.1Q tag applies to all Ethernet ports on the
device.
Example 802.1ad configuration
Figure 89 shows an example 802.1ad configuration.
FIGURE 89 Example 802.1ad configuration