Hardware Installation Guide Manual

Port status LEDs TABLE 7
LED Condition Status
Off A link is not established with a remote port.
FIGURE 19 System status LEDs
1. System status LEDs
System status LEDs TABLE 8
LED Condition Status
PS1
PS2
(Power Supply Status)
Green Power supply is operating normally.
Amber Power supply fault.
Off Power off or failure.
Diag
(Diagnostic)
Flashing Green System self-diagnostic test in progress.
Green System self-diagnostic test successfully completed.
Amber System self-diagnostic test has detected a fault.
(Blower, thermal or any interface fault.)
A or S
(Active or Standby)
Green The device is the Active controller. If this LED is
flashing green, the system is initializing.
Amber Indicates the device is the Standby controller.
Off Device is operating as a stack member, or is in
standalone mode.
Up Link or Down Link (Stacking uplink or
downlink port status)
Green Uplink is operating normally.
Off Uplink has failed or there is no link.
Product Overview
26 Brocade FCX Series Hardware Installation Guide
53-1003077-01