Installation Procedure (Supporting 300, 5100, 5300, 6505, 6510, 6520, 7800, 8000, VA-40FC, VDX 6710-54, and VDX 6740) Owner manual

8 of 10 Mid-Mount Rack Kit (Switch) Installation Procedure
53-1001273-07
Attaching the switch to a rack
Complete the following steps to install the switch in the rack.
1. Position the switch in the rack (Figure 3), providing temporary support under the switch until the rail kit is
secured to the rack.
2. Attach the right front bracket to the right rack rail using three 10-32 x 5/8-in. screws and three 10-32 retainer
nuts.
3. Attach the left front bracket to the left rack rail using three 10-32 x 5/8-in. screws and three 10-32 retainer
nuts.
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lbs (29 cm-kgs)
FIGURE 3 Attaching the switch to a rack
1 Bracket, front right 3 Retainer nut, 10-32
2 Screw, 10-32 x 5/8-in., panhead Phillips
321